Porsche 911S 2.2 engine

1971 2.2 Porsche 911S engine

This 1971 2.2 911S engine was last known to have run in 1984! The project was a full strip down and assessment. Higher compression pistons were then fitted and all fittings were re-plated and powder coated.

Stripped Porsche engine

Porsche engine stripped

The latest project – engine stripped, ready for full measurement and assessment.

Porsche manifold

3.2 topend rebuild

This job was a 3.2 topend rebuild, where the customer wanted to back date the exhausts to SSI’s plus a bit of plating and blasting.

Porsche 924S

Porsche 924S back up and running

This is an ongoing project. It is a 924S which hasn’t been started for four years. So far, after a couple of hours work she is up and running! Check back for progress updates.

Porsche cylinder heads

Cylinder heads rebuilt

These cylinder heads have been vapour blasted and rebuilt with new guides and valves. The original studs were removed wire, wheeled, polished up and replated.

911E engine

Engine rebuild on a 73 2.4 911E

I have just rebuilt this 1973 2.4 911E engine to spec and fully restored. This one is ready to road test.

Porsche 914 before restoration

The Porsche 914 2.3 ST

This is our very own project – restoration and build all rolled into one. I bought the car in 2016. It was a very original, honest 74 2.0L. It also had the honesty of extremely bad rot! It is something that I am doing when I have time. It does need a lot of it!…
Read more

High compression barrel and piston kit fitted

Stripped this beauty back and gave her a new lease of life. High compression barrel and piston kit and some head tweaks should see some improvement in performance.